FUEL SYSTEM TESTER

9 Pcs Turbo System Tester Set, 51103

Features: Designed to check leakage in the turbo system as pressure hoses, charge air coolers, etc. using a air compressor.
Helps locate air leaks in turbine system components by blocking the output side and air intake of the turbine.

Pressure gauge with shut-off valve and regulator to prevent overpressure.
Suitable for most turbo vehicles: Includes 4 pairs of stepped plugs for clogging intake and exhaust hoses.
Contents: Filling fitting with pressure gauge 0-70 psi (0-5 bar), suitable for the following hose sizes: 35 - 40 - 45 - 50 - 55 - 60 - 65 - 70 - 75 - 80 - 85 - 90 mm

Made in China

Vacuum & Fuel Pump Pressure Test Gauge Set, 50190

Detects gasoline leaks, sticky valves, weak valves, damaged valves, and checks the fuel pump pressure.
Purpose: Tests the suction and pressure of the fuel pump.
Features:
Double calibrated scale:
SAE and Metric (0-30 in-Hg / 0-700 mm-Hg) for vacuum.
Scale from 0 to 10 PSI (0 to 700 g / cm2) for mechanical systems for fuel pumps.
A flexible hose and sharpened fittings are included in the kit.
Application:
Quickly diagnose of internal motor problems.
Description
• The kit comes with brass fittings for vacuum and fuel pipe connection, 2.5 ft. pipe adapters, suitable for most vehicles.
• Pressure gauge with a diameter of 10.5 cm (4 ”),
• Flexible hose 77.5 cm (30 ”).
• Fuel pump outlet pressure tested: 10PSI.

Fuel Injection test kit, 50195

Description:

Fuel injection test set, 50199

The car fuel pressure diagnostic kit is suitable for most vehicles with a fuel injection system with petrol or gas engines (except Bosch, CIS Jetronic, Throttle Body Systems on GM cars).
Not suitable for diesel engines with high pressure injection pump or direct injection engines due to the low pressure range of the manometer.
Fuel pressure testing is an essential part of the fuel injection system troubleshooting process.
Contents:
The set is equipped with various fittings and connection hoses for testing.
15 "length hose is used for direct connection to 1/4" SAE standard fuel pump shredder valve
An 8 "length hose is for the M6 ​​fuel pressure test hole, and there are also adapters M8; M10; M12; M14 for the corresponding test port on fuel rail.
Aluminum tee to support the connection between the fuel pump and the engine for most cars.
Manometer, protected with a rubber shell, with a diameter of the dial 3-1 / 2 ", with a range of 0-10bar (0-140psi) and two-color coded scale for easy reading. The hoses use rubber nylon resin and the built-in nylon can strengthen the hose with increased stress resistance. The pressure relief valve and 16 "fuel drain hose help to safely release the pressure and easily restore the fuel.
Fuel pump pressure check:
The manometer is designed to easily and quickly check the pressure of the fuel injection pump and the fuel flow.
You can compare the pressure value with the manufacturer's recommended reference range to help diagnose the petrol engine system.
Low fuel pressure can be caused by kink/leak/clog on inlet supply side components, a bad fuel pump or regulator, low tank pressure
High fuel pressure may be caused by a bad fuel pressure regulator or kincked outlet return line.

Made in China